Quick Reference Guide to Administration Procedures
This chart summarizes the administrative procedures described on pages 26 through 82. For more information about a procedure, refer to the page listed.
Before you perform any of these procedures, enter administrationmode by following the steps below.
●Set switch A on the Processor Module in the control unit toAdminister (down).
●Insert the administration mode button labels (see the back of this manual) in the administrator/attendant console.
●Slide the T/P switch on the left side of the console to P.
When you finish administeringyour system, leave administration mode by following the steps below.
●Slide the T/P switch to the center position.
●Set switch A on the Processor Module to Attendant (up).
●Remove the administration mode button labels from the console and insert the regular
Procedure | Touch |
|
| Then |
|
|
|
|
|
PERFORM BASIC ADMINISTRATION |
|
|
|
|
Specify | Adm Misc | ● Dial #302. |
|
|
dialing. |
| ● Touch line buttons. |
| |
(See page 26.) |
| Steady green on = | ||
| Green off = rotary | |||
|
| ● Touch Adm Misc. |
| |
|
|
| ||
Assign lines to voice ter- | Adm Tel | ● Touch Auto Intercom button representing voice terminal. | ||
minals in square systems. |
| ● Touch line buttons. |
| |
|
| Steady green on | = line is assigned | |
(See page 27.) |
| Green off = line is not assigned | ||
|
| ● Touch Adm Tel. |
|
|
|
|
| ||
Set up line pools in pooled | Adm Pool | ● Dial pool code (9 for main pool or 890 through 899 for addi- | ||
systems. |
| tional pools) if administering more than one line pool. | ||
|
| ● Touch line buttons. |
| |
(See page 31.) |
| Steady red on | = line is in pool | |
|
| Red off | = line is not in pool | |
|
| ● Touch Adm Pool. |
| |
|
|
| ||
Assign lines and line pools to | Adm Tel | ● Touch Auto intercom button representing voice terminal. | ||
voice terminals in pooled |
| ● Touch line buttons. | line or pool assigned | |
systems. |
| Steady green on = | ||
|
| Green off = line or pool not assigned | ||
(See page 33.) |
| ● Touch Adm Tel. |
|
|
|
|
| ||
Assign Dial Access to Line | Adm Tel | ● Touch Auto Intercom button representing voice terminal. | ||
Pools. |
| ● Touch same Auto Intercom button again. | ||
|
| ● Touch line buttons. | dial access to pool containing line | |
(See page 38.) |
| Steady green on = | ||
Green off = no dial access to pool containing line ● Touch Adm Tel.
