SPECIFYING TOUCH-TONE OR ROTARY DIALING
When your system is installed, it is set to generate
To determine if your lines are
If a line is rotary, you hear tones but the dial tone is not interrupted. Follow the pro- cedure below to specify
1.If you have not already done so, enter administration mode by following the boxed instructions on page 25.
2.Touch Adm Misc.
The lights next to the administration mode buttons stop flashing, and the green light next to Adm Mist remains on.
3.Dial the
4.One by one, touch the line button for each line in your system until the green light beside it shows the appropriate code. Each successive touch of a but- ton gives you one of the following codes:
Steady green on =
Green off = rotary signaling
5. Touch Adm Misc again.
The lights next to the administration mode buttons flash.
6.Continue to administer your system or leave administration mode by follow- ing the boxed instructions on page 25.
2 6