Avaya Distributed Office
An i40 might provide an adequate number of lines and trunks for the current business requirements but not for increased requirements in two years based on growth assumptions. Or, an i40 might provide enough lines and trunks for the next several years but another parameter, such as the number of DSPs to handle large Fax volumes might not be sufficient. In either case, one of the i120 constructs would be a better choice.
Table 1: i40 constructs on page 27 and Table 2: i120 constructs on page 29 provide the information needed to choose a construct.
Note:
The list of available constructs might change over time. Check on the Avaya Distributed Office web site for the latest set of available constructs.
i40 constructs
Each i40 construct contains the following ports:
●One console cable port
●One interface USB port (located on the chassis where you connect the Disk on Key)
●One Contact Closure Adjunct (CCA) port
●One Ethernet WAN port (not used with Distributed Office)
●Eight Ethernet LAN Power over Ethernet (PoE) ports
●One USB port (for use with a USB modem for servicing the platform)
●One Ethernet services port
●Two analog line ports
In addition to these ports, the i40 contains additional ports based on its construct. Table 1 shows the three i40 constructs, and a description of what additional ports are available for each.
Table 1: i40 constructs
|
| Analog | ISDN BRI | T1/E1 |
|
| trunk | trunk | interface |
Construct | ports | ports | port1 | |
i40 | - Analog | 4 |
|
|
|
|
|
|
|
i40 | - BRI | 1 | 2 |
|
|
|
|
|
|
i40 | - DS2 | 1 |
| 1 |
1.The T1/E1 interface port can be configured for ISDN PRI, Robbed Bit, or CAS signaling.
2.The i40 - DS1 construct also contains three pairs
of test jacks that are used by service personnel only.
Issue 6 January 2008 27
