5-82 Compact T1 - Release 6.1
CLI Commands
set
set ipds0
Use the set ipds0 command to setup the DS0 management channel.
Note: the DS0 selected as the DS0 management channel can only reside on the Controller T1.
Syntax: set ipds0 {setting} [ds0-addr|ip-addr]
Example: set ipds0 assign a:1:24
The example sets the DS0 management channel to slot A (Controller), port 1,
channel 24.
{setting}
[ds0-addr|ip-addr]
In the form {slot:port:channel}.
assign Assign the DS0 as the IP management channel
delete Removes the IP over DS0 management channel (Default)
down Set the DS0 management channel down (Default)
ip address Set the DS0 management channel’s IP address and optional subnet mask
up Set the DS0 management channel up (enables)
slot A for the controller card
port Port number or range.
channel Channel number or ranges.
ip-addr Setup the DS0 management channel IP address and the optional subnet
mask, in the form of xxx.xxx.xxx.xxx, where xxx is between 0-255.