Compact T1 - Release 6.1 10-11
OCU-DP Card
Jumper Settings
Jumper Settings
The P1 and P2 Jumpers are defaulted to RJ-48S, which are the set of pins nearest the
bottom of the service card. With the jumper in this posit ion the signals ar e routed t o the
RJ-48S connector(s) on the face of the card. To route the signals to the 25-pin Telco
connector at the rear of the unit, move the jumpers to the backplane po sit ion, which is
the set of pins toward the top of the service ca r d.
P1 applies to connectors 1 and 2 (connector 2 only with the 4 port card).
P2 applies to connectors 3 and 4 (for the four port card only).
P1 is set to P2 is set to
25-Pin TelcoRJ-48S Position Position
Top of Card
Front of
Card