4-2 Compact T1 - Release 6.1
Configuration
Setting up a CLI Connection
Setting up a CLI Connection
NOTE: Default IP address of the Controller (T1) is 10.0.0.10.
To connect with CLI, set up the connection:
lIf connecting via the ethernet 10Base-T connection, use a Telnet TCP/IP
program to access the CLI. This requires an IP address of the Controller. The
Controllers are shipped with the IP address set to 10.0.0.10, if this address has
been changed and is not known, use Hyperterm to access the Controller and use
the CLI command show ip. If an IP address needs to be set use the CLI
command set ethernet ip address.
lIf connecting via RS-232, the port settings should be set to:
Bits per second: 9600 Data bits: 8
Parity: None Stop bits: 1
Flow control: None
lSet your Terminal Emulation to: VT100
NOTE: Note: When using Tera Term TCP/IP, CLI commands will not be
recognized until the following setup is completed.
lIn Tera Term go to Setup/Terminal.
lSet the New-line/Transmit value"CR+LF".
Local vs. Remote Configuration
lFor remote configuration via the CLI, use the se t local off command.