5-168 Compact T1 - Release 6.1
CLI Commands
set
set (router-trunk) voice bandwidth limit
Use the set (router-trunk) voice bandwidth limit command to specify the maximum
percentage of bandwidth on this trunk that voice calls are allowed to consume. The remaining
percentage of the bandwidth on a CMG trunk to be reserved for routed or bridged data. Routed
or bridged data is allowed to use any available bandwidth, but it is carried at a lower priority
than the voice. If the bandwidth required to carry an additional VoIP call will put the total
bandwidth used by VoIP calls above that allowed for voice on the trunk, then the call will be
denied and the caller will hear the all-circuits-busy tone. This command applies to the CMG
Router card only.
Syntax: set {cmg-trunk-addr} voice bandwidth limit {percent}
Example: set 2:1:1 voice bandwidth limit 90
The example will limit voice calls to 90% of the bandwidth on trunk 1 of the
CMG card in slot 2.
{cmg-trunk-addr}
{percent}
The maximum percentage of VoIP bandwidth. Range is 0 - 100.
slot The slot number (1-6) that contains the CMG card.
port Port number of the Router is 1.
trunk Trunk number for this port, 1-24.