5-108 Compact T1 - Release 6.1
CLI Commands
set
set (router) mgcp Use the set (router) mgcp command to setup Media Gateway Call Protocol (MGCP)
parameters. This command applies to the CMG Router card only.
set (router) mgcp addressformat
The set (router) mgcp addressformat is an interoperability command. It is used to remove
or put square brackets around IP Addresses in transmitted MGCP commands. The standard
convention and default setting is to have the brackets. The CMG is capable of receiving
either format regardless of this setting. This command applies to the CMG Router card
only.
Syntax: set {cmg_card-addr} mgcp addressformat
{brackets|nobrackets}
Example: set 1 mgcp addressformat nobrackets
The example will remove brackets from around IP addresses in MGCP
commands issued by the CMG card in slot 1.
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{brackets|nobrackets}
brackets MGCP will place brackets around IP addresses (Default)
nobrackets MGCP will not place brackets around IP addresses