Compact T1 - Release 6.1 5-139
CLI Commands
set
set (router) stp
Use the set (router) stp commands to configure the Spanning Tree Protocol on the Router.
Note: Enter {slot} only. If {slot:port} is entered the command will be directed to the Router
LAN and not the Router Card.

set (router) stp bridge forwarddelay

Use the set (router) stp bridge forwarddelay command to configure Spanning Tree
bridge forward delay value for the bridge. The bridge forward delay is the time spent by a
Port in the Listening or Learning States before the transitioning to the Learning or
Forwarding State, respectively.
Syntax: set {rtr_card-addr} stp bridge forwarddelay {value}
Example: set 3 stp bridge forwarddelay 15
The example will set the Spanning Tree bridge forward delay time to 15
seconds, on the Router in slot 3.
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{value}
The value can range from 4 to 30 seconds, with a default of 15.

set (router) stp bridge hellotime

Use the set (router) stp bridge hellotime command to configure Spanning Tree bridge
hello time value for the bridge.
Syntax: set {rtr_card-addr} stp hellotime {value}
Example: set 3 stp bridge hellotime 3
The example will set the Spanning Tree bridge hello time to 3 seconds, on the
Router in slot 3.
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{value}
The value can range from 1 to 10 seconds, with a default of 2.