Compact T1 - Release 6.1 5-163
CLI Commands
set
set (router-lan) stp
Use the set (router-lan) stp commands to configure the Spanning Tree Protocol on this
interface.

set (router-lan) stp enable/disable

Use the set (router-lan) stp enable/disable command to enable/disable Spanning Tree
Protocol on this interface. To enable STP on an interface it must be enabled globally with
the set (router) stp enable command.
Syntax: set {rtr_lan-addr} stp {disable|enable}
Example: set 3:1 stp enable
The example will enable Spanning Tree on the LAN for this interface.
{rtr_lan-addr}
The Router (IP or CMG) address is in the form {slot:port} or {slot "profile-name"}.
{disable|enable}
slot Slot number (1-6) that contains the Router card.
port Port number of the Router is 1.
"profile-name" The profile name for the Router interface. Name must be enclosed in
quotes, with a maximum length of 11 characters.
disable Disable Spanning Tree on this interface.
enable Enable Spanning Tree on this interface.