16-4 Compact T1 - Release 6.1
Maintenance
Software Upgrade
Upgrading System and Router Software via TFTP using Proxy
Required: - Router Service card (IP or CMG) release 1.32 or higher
- Controller software 3.2 or higher
- Ethernet cable connected to port on front of Router card
1. Set up the Proxy with the following commands
set ethernet ip address {ip-addr} [mask]
set {rtr_lan-addr} ip address {ip-addr} [mask]
set {rtr_card-addr} proxy enable {ip-addr} [mask]
set ip gateway {ip-addr}
Example: (example with router in slot 3)
set ethernet ip address 10.0.0.1 255.0.0.0
set 3:1 ip address 192.168.100.1/24
set 3 proxy enable 192.168.100.80/24
set ip gateway 192.168.100.80
NOTE: See Chapter 5,CLI Commands for more information on these
commands.
1. Login to the Compact T1 using the Proxy IP address, (example:
192.168.100.80) using a terminal emulation program or via Telnet.
2. Enter: load [slot] tftp {ip-addr} "file-name"
where [slot] = the slot number of a router card. If no slot number is listed, the
file is loaded to the Controller.
{ip-addr} = the IP address of the host device holding the downloadable
software
"file-name" = the software file name, including path, if needed. Enclosed in
quotes. Example: "c:\unit_sw\tdm4_0_z_all.mgm".
This example loads tdm4_0_z_all.mgm via tftp from the C drive and unit_sw
subdirectory. The path information must be provided.
The tftp utility provided with the downloadble software must also be running,
in the same directory as the software file.