12-6 Compact T1 - Release 6.1
Quad T1 Card
Card Configuration
Card Configuration
All options on the Quad T1 cards are set using the Command Line Interface (CLI). The
default for the connectors are the RJ-48s on the front of the T1card, however by moving
the jumpers to the backplane, the Telco connectors on the back of the unit are enabled.
See Jumper Settings on page 12-7 for more information.
CLI Commands
The following commands are used to configure the Quad T1 card. For detailed
information on these commands, see Chapter 5, CLI Commands.
l connect
Creates two-way connections between ch annels.
l disconnect
Removes a connection created by the connect command.
l set (ds1)
Sets up the DS1 interfaces (clock, up, down, equipment loopup, fdl, framing,
id string, lbo, line loopup, linecode, loopdetect, payload loopup, threshold).
l show (ds1)
Displays current settings for DS1 (circuit ID, up.down, framing, line codin g,
clock source, line build out, loop code detection, loop back, fdl type).
l status (ds1)
Displays the status of the DS1 (receive, transmit, loopback).