7-6 Compact T1 - Release 6.1
FXO Voice Card
Card Configuration
Card Configuration
The FXO voice card can be configured, using DIP switches on the card, to support
either FXO loop start or FXO ground start signaling, with various transmi t and re ceive
attenuation options.
Note that the attenuation settings you configure via DIP switches apply to all eight
channels on a card. If you want different attenuation options for individual channels,
use the Command Line Interface to configure your FXO channels.
CLI Commands
The following commands are used to configure the FXO card. For detailed in formation
on these commands, see Chapter 5, CLI Commands.
l connect
Creates two-way connections between channels
l disconnect
Removes a connection created by the conn ect command
l set (fxo)
To setup the voice channels parameters (rx gain, signal, tx gain)
l show (fxo)
Displays the settings (type, signaling, RxGain, TxGain) for the FXO
l status (ds0)
Displays the status (AB bits received, AB bits transmitted, signal, trunk
processing) of the DS0s (AB Bit Monitoring)
l status (fxo)
Displays the status (AB bits received, AB bits transmitted, signal, T1
activity, trunk processing) of the specified FXO (AB Bit Monitoring)