5-60 Compact T1 - Release 6.1
CLI Commands
load
load xmodem
Use the load xmodem command to download software via Xmodem. This command is only
available with RS-232 connections. If you are using Telnet, see load tftp command.
Example: load xmodem
Download to Active controller using xm od em.
Type ACTIVE Software Release Key, or Hit ’Enter’ for Non-Keyed Load:
>>>
At the prompt enter Software Key or [Enter] to download non-keyed version.
load xmodem command will be executed
Do you really want to do this?
Enter Y at the prompt to continue, or N to cancel the download.
Y - the system will prompt you to select the appropriate local file. With the file selected, the
system will complete the download, reboot, and run the installation for flash upgrade. Screen
example following.
**** System Boot ****
XMODEM transfer started
Validating image(fast)..........................SUCCEEDED!
Erasing FLASH:..........................Finished Erasing FLASH!
Erasing FLASH:..........................Finished Erasing FLASH!
Programming Flash..........................SUCCEEDED!
In 5 seconds the system will boot from Flash
Press any key to stop boot . 5 . 4 . 3 . 2 . 1 . 0
Looking for valid application image in Flash...
Executing application image from Flash
Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
ADIT startup