5-80 Compact T1 - Release 6.1
CLI Commands
set
set (fxs5G)Use the set (fxs5G) command to setup voice channels of an FXS 5G card. The command
specifies the list of voice channels, and the setting to apply.
Syntax: set {fxs5G-addr} {setting}
Example: set 3:1-8 impedance 19
Sets the impedance of the FXS 5G card, in slot 3, to 900 ohms +2.16µF
(µ-Law), see show impedance for the listing of index numbers.
{fxs5G-addr}
Voice channels to apply setting to, in the form of {slot:port}.
{setting}
slot Slot number 1 - 6, location of the FXS 5G card
port Port number or range
impedance Sets the line impedance (see the following chart). Default for the FXS
5G is index 19 (900 ohms +2.16µF µ-Law)
See show impedance command.
rxgain The Receive direction is Network to Analog, with a range of -12 to +6
(dB). Available in .25 dB increments.Default setting is -6
signal Set the DS0 signaling type
gs Set to Ground Start signaling
gsrb Set to Ground Start signaling with reverse battery
gsw Set to Ground Start Wink signaling
gswrb Set to Ground Start Wink signaling with reverse battery
ls Set to Loop Start signaling
lsrb Set to Loop Start signaling with reverse battery
txgain The Transmit direction is Analog to Network, with a range of -12 to +6
(dB). Available in .25 dB increments. Default setting is -3
winktime Set the wink time from 105 ms to 300 ms in 3 ms increments. Enter
value or type "Default" (135 ms). Setting the wink time for any channel
sets it for all channels on this card.