5-8 Compact T1 - Release 6.1
CLI Commands
add
add (router) snmp community
Use the add (router) snmp community command to add a SNMP community to an interface
on the specified Router card.
Syntax: add {rtr_card-addr} snmp community {both|read|write}
{"community-name"} {ip-addr}
Example: add 2 snmp community both "commune" 192.168.100.245
The example will allow the host 192.168.100.245 read/write access to the
Router card SNMP agent using the community name "commune". The Router is
located in slot 2.
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{both|read|write}
{"community-name"}
Name of the community to add with a maximum length of 10 characters. Must be enclosed
in quotes.
{ip-addr}
The IP address of the host that can access the SNMP agent via this community, in the form
of xxx.xxx.xxx.xxx, where xxx is between 0-255. The address "0.0.0.0" allows any host.
both Will set the community to be read/write
read Will set the community to be read-only
write Will set the community to be write-only