OMNISCANNER
4. Press 
.
METHOD B
To run an Autotest when Method B was used to set the Reference proceed as follows:
2 m Launch Cable
| RX |
850 nm 1300/1310 nm | TX |
METHOD B
Cable under Test
Wall Plate
2 m Launch Cable
Patch Panel
TX | 850 nm 1300/1310 nm |
RX |
|
1.Do not disconnect the black connectors which are attached to the TX port of the OMNIFiber Adapters.
2.Disconnect the black connectors that are attached to the RX ports of the OMNIFiber Adapters.
3.Connect the white connectors to the RX ports on the OMNIScanner fiber adapters.
4.Connect the OMNIFiber Main to one end of the duplex link under test and the OMNIFiber Remote to the opposite end.
5.Press 
.
METHOD C
To run an Autotest when Method C was used to set the Reference, proceed as follows:
46
