Bradley Smoker PLC-5 Adapter module, Indicators are still blinking, check, Mode adapter to

Troubleshooting F-7

Indicators			Description	Probable Cause	Recommended Action
Active	Adapter	I/O
	Fault	Rack
Blink alternately		Off	Adapter module not	Controller restart lockout switch on	Press reset button to clear lockout feature
			actively controlling I/O(2)	chassis backplane switch assembly	or cycle power; if after repeated attempts
			Adapter module in	on(3)	indicators are still blinking, check:
					• push button not wired properly to field wiring
			controller restart lockout
			mode (adapter to			arm
					•	wiring arm not connected to adapter module
			scanner link is normal)
					•	adapter module was reset by process or/
						scanner, then immediately faulted

(1)If a fault occurs and the Controller is in the run mode but is actually operating in the dependent mode, the chassis fault response mode is selected by the last state switch on the chassis backplane.

(2)The I/O chassis is in faulted mode as selected by the last state switch on the chassis backplane.

(3)You must select the operating mode of the remote I/O adapter module as outlined in the publication furnished with the remote I/O scanner/distribution panel, remote I/O scanner-program interface module, or I/O scanner-message handling module. Pay close attention to the disable search mode in the 1771-SD, -SD2.

Publication 1785-UM012D-EN-P - July 2005