Bradley Smoker PLC-5 You jumped to an invalid non-ladder file, For instruction with missing NXT

B-6Processor Status File

This
Fault
Code	Indicates this Fault	And the Fault Is
30	You tried to jump to one too many nested subroutine files	Non-recoverable
31	You did not enter enough subroutine parameters	The fault routine will be executed
32	You jumped to an invalid (non-ladder) file	but cannot clear major fault bit 2.
33	You entered a CAR routine file that is not 68000 code
34	You entered a negative preset or accumulated value in a timer instruction	Recoverable

35You entered a negative time variable in a PID instruction

36You entered an out-of-range setpoint in a PID instruction

37You addressed an invalid module in a block-transfer, immediate input, or immediate output instruction

38	You entered a RET instruction from a non-subroutine file	Non-recoverable
		The fault routine will be executed
39	FOR instruction with missing NXT
		but cannot clear major fault bit 2.
40	The control file is too small for the PID, BTR, BTW, or MSG instruction	Recoverable
41	NXT instruction with missing FOR	Non-recoverable
42	You tried to jump to a non-existent label	The fault routine will be executed
43	File is not an SFC	but cannot clear major fault bit 2.

44Error using SFR. This error occurs if:

•you tried to reset into a simultaneous path

•you specified a step reference number that is not found or is not tied to a step (it is a transition)

•the previous SFR to a different step is not complete

45	Invalid channel number entered	Recoverable
46	Length operand of IDI or IDO instruction is greater than the maximum allowed
47	SFC action overlap. An action was still active when the step became re-activated	Non-recoverable. The fault
		routine will be executed but
		cannot clear major fault bit 2.

Publication 1785-UM012D-EN-P - July 2005