Initial Configuration

If this Hub unit is providing the TDM outbound, a route statement or state- ments defining satellite communications with the Remote units must be entered as well. One recommended option is to enter a single super-route that will handle satellite communications with all of the remote subnets; an example of this is shown as Route002 in figure 2-6,above.

4.Enter S at the command prompt in figure 2-6to save the settings to flash.

Set the Satellite Modem Configuration

1.Enter M from the Main Menu, then enter C from the Satellite Modem menu to access the Configuration screen.

2.Enter T to access the Tx Configuration screen shown in figure 2-7.Set the Tx parameters for Frequency, Data Rate, FEC, Code Rate, and Modulation as specified by the network administrator.

Note that only Turbo Product Coding is acceptable for FEC when the CDM-570/570L is running in Vipersat mode.

Figure 2-7Tx Configuration screen

3.Enter R to access the Rx Configuration screen, and set the Rx parameters as specified by the network administrator.

4.Save the settings to flash by entering S at the command prompt.

2-10

Vipersat CDM-570/570L User Guide

Page 32
Image 32
Cables to Go CDM-570L manual Set the Satellite Modem Configuration, 7Tx Configuration screen