Vipersat Configuration

Figure 3-54Minimum Power Level prompt (CDM-570L)

The value entered sets the minimum power level allowed by all SCPC modula- tors.

Max Step Down Power

The Maximum Step Down Power value sets the largest step reduction in trans- mit power permitted when the DPC is adjusting the power downward to achieve the target set point. The default value for this parameter is 3 dB.

Enter D at the command prompt to display the Max Step Down Power dialog shown in figure 3-55.

Figure 3-55Maximum Step Down Power prompt

Max Step Up Power

The Maximum Step Up Power value sets the largest step increase in transmit power permitted when the DPC is adjusting the power upward to achieve the target set point. The default value for this parameter is 3 dB.

Enter U at the command prompt to display the Max Step Up Power dialog shown in figure 3-56.

Figure 3-56Maximum Step Up Power prompt

Chapter 3 - Using the Command Line Interface (CLI)

3-41

Page 75
Image 75
Cables to Go CDM-570L manual Max Step Down Power, Max Step Up Power