Cables to Go CDM-570L manual Set Home State Parameters, Target DPC Address

Vipersat Configuration

Enter Q at the command prompt in the DPC Configuration screen to display the Speed Up EbNo dialog shown in figure 3-59.The default value for this parameter is 5 dB.

Figure 3-59Speed Up EbNo prompt

Target DPC Address

The Target DPC Address identifies the modem that is transmitting to this CDM-570/570L, and will be receiving the PLDM messages that provide the current Eb/No value for this CDM-570/570L. Typically, all Remotes will spec- ify the Hub modem that is supplying the TDM outbound. The Outbound IP address is sent out to all STDMA Remotes via the Burst Map, and the DPC Target for these Remotes is automatically mapped to that address. When operat- ing in a dedicated SCPC mode, the Remote’s Target DPC Address is configured manually with this command.

Enter 1 at the command prompt to display the Target DPC Address dialog shown in figure 3-60.

Figure 3-60Target DPC Address prompt

The STDMA Burst Controller is not permitted to specify a DPC Target because the demodulator is receiving multiple bursts very rapidly from all Remotes in the group and is unable to utilize DPC to control the transmit power of the remote modems.

Set Home State Parameters

ACDM-570/570L’s Home State are those parameters which the CDM-570/ 570L will return to when it is power cycled or reset. Enter H at the command

Chapter 3 - Using the Command Line Interface (CLI) 3-43