Cables to Go CDM-570L manual Delete Remote, Enable/Disable Remote, View Remotes

Vipersat Configuration

Figure 3-24Global Switch Type prompt

Delete Remote

Entering D at the command prompt shown in figure 3-16brings up the Delete Remote dialog shown in figure 3-25.

Figure 3-25Delete Remote prompt

Enter the number of the Remote CDM-570/570L at the command prompt to delete it from the STDMA group for this Hub modem.

Enable/Disable Remote

Enter E at the command prompt in figure 3-16to display the dialog shown in figure 3-26.The Remotes in the STDMA group are displayed, indicating whether each is currently Enabled (E) or Disabled.

Figure 3-26Enable/Disable Remote prompt

Enter the number of the Remote at the command prompt to toggle the Remote from its current Enable/Disable configuration.

View Remote(s)

Entering V at the command prompt shown in figure 3-16will display the listing of Remote(s) that belong to the STDMA group for this Hub modem, as shown in figure 3-27.

Chapter 3 - Using the Command Line Interface (CLI) 3-19