Cables to Go CDM-570L manual 1Main Menu screen

Initial Configuration

Figure 2-1Main Menu screen

2.From the Administration screen shown in figure 2-2,select the Features Configuration command by entering F at the command prompt.

Figure 2-2Administration screen

3.From the Feature Configuration menu shown in figure 2-3,verify whether or not the Vipersat Feature Codes appear as shown in the figure. These codes are entered prior to shipment from the factory; however, if the unit has been reset, the codes will have to be re-entered. If the feature codes are not displayed in the menu, enter F at the command prompt, then enter the 3 digit Feature Code followed by the Unlock Code, as shown in figure 2-4.

Chapter 2 - Quick Start Configuration 2-5