Vipersat Configuration

Figure 3-34STDMA/SCPC Auto Switching screen (Remote)

Auto Switching

The Auto Switching item is for information only and shows the current config- uration of the target CDM-570/570L. This feature is Enabled and Disabled as described in section “Feature Configuration” on page 3-4.Auto Switching must be Enabled in order to utilize any of the related features/commands in this menu.

Current WAN Transmit Mode

The Current WAN Transmit Mode item is for information only and reflects the current status of the CDM-570/570L. If the CDM-570/570L is functioning as a Hub in the network, this item will always read Continuous as shown in figure 3-33.If the CDM-570/570L is functioning as a Remote in the network and STDMA is enabled on the target CDM-570/570L, this item will show STDMA (Burst) as shown in figure 3-34.

Tip: This menu item is useful for determining whether a Remote modem is currently operating in STDMA or SCPC mode.

Voice & Video Application Switching

One of the four automatic switching functions that the Vipersat CDM-570/570L is able to perform is Application Switching. The Vipersat CDM-570/570L provides application switching for non-encrypted SIP and/or H.323 traffic that is detected on the satellite network. When encryption prevents the detection of this type of traffic, an alternate means of SCPC switching can be configured using the ToS auto switching feature.

3-24

Vipersat CDM-570/570L User Guide

Page 58
Image 58
Cables to Go CDM-570L manual Auto Switching, Current WAN Transmit Mode, Voice & Video Application Switching