Cables to Go CDM-570L manual Initial Configuration

Initial Configuration

6.Enter V at the command prompt to set the Receive Multicast Address. The Receive Multicast Address is the multicast IP address assigned to the VMS and to all units in the network. The Hub modem transmits the multi- cast to this IP address, and the Remotes receive the multicast on this address.

7.Enter I at the command prompt to set the Managing IP Address. The Managing IP Address is the IP address of the VMS server.

8.Enter H to go to the Home State Configuration menu screen, then enter W to set the current configuration as the home state.

9.Save the settings to flash by entering S at the command prompt.

This completes the initial configuration of a CDM-570/570L from the factory default settings to a functioning, Vipersat-enabled unit. Additional configura- tion parameters must be set depending on the network requirements for a specific application.

Refer to Chapter 3, “Using the Command Line Interface,” for additional details on configuring the target Vipersat CDM-570/570L.

2-12 Vipersat CDM-570/570L User Guide