Chapter 3 - Using the Command Line Interface (CLI) 3-13
Vipersat Configuration
Figure 3-12
Cycles per Burst Map prompt
Slot Guardband
This menu item displays the current length of the slot guardband in milli-
seconds and the size of the guardband in bytes for the target CDM-570/570L.
Figure 3-13
Slot Guardband prompt
On a Hub unit, this value can be modified by entering G at the command
prompt to display the dialog shown in figure3-13 and entering a new value.
On Remote units, this menu item is an information-only display.
Note: Note that the value you enter at the command line in figure 3-13
is in milliseconds. The corresponding value expressed in bytes is
calculated by the CDM-570/570L based on the STDMA transmit
bit rate as shown in the menu in figure 3-6.
Slot Preamble Length
This menu item displays the current slot preamble size in milli-seconds and
bytes for the target CDM-570/570L.
Figure 3-14
Slot Preamble Length prompt
On a Hub unit, entering P at the command prompt allows changing the pream-
ble duration in milliseconds.
On Remote units, this menu item is an information-only display.
NOTE