Cables to Go CDM-570L manual Vipersat Migration, 74Vipersat Summary screen

Vipersat Configuration

Figure 3-74Vipersat Summary screen

The Node ID number that appears in this screen verifies that the unit is regis- tered with the VMS and is active in the network. This number is automatically assigned by the VMS.

The two frequency listings are for the modulator (0) and the demodulator (1) for the CDM-570/570L. The IF values represent the Intermediate Frequency (Hz) that this unit is currently using. The AF values represent Adjusted Frequency (Hz), a translation of the IF that is used by the VMS for internal tracking of switching commands.

The DPC target entry is the IP address of the modulator that is to receive the DPC messages from this unit.

The Primary Heart Beat Interval represents the time period between the communication check message that is sent from the primary Hub modem to the VMS in an N:M redundancy configuration. This interval is specified in the VMS.

Vipersat Migration

The Vipersat Migration command is used to set the compatibility mode for the Hub Burst Controller when conducting a firmware upgrade on the associated CDM-570/570L Remotes. Although this command appears in the menu for both the Hub modem and the Remote modem, it only applies to STDMA Controllers and TDM Outbound modems at the Hub.

Enter M at the command prompt in the Vipersat Configuration screen to display the Vipersat Migration dialog shown in figure 3-75.

3-50 Vipersat CDM-570/570L User Guide