Chapter 3 - Using the Command Line Interface (CLI) 3-7
Vipersat Configuration
Vipersat Configuration
Enter V at the command prompt from the CDM-570/570L Main Menu shown
in figure 3-1 to display the Vipersat Configuration screen shown in figure 3-5.
Figure 3-5
Vipersat Configuration screen (Hub)
This menu lists the available commands for configuring a Vipersat CDM-570/
570L. Note that for the Hub modem only, the command Primary Heart Beat is
displayed in the Vipersat Configuration screen. For the Remote modem only,
the status of the Home State Revert setting is displayed.
Each of these commands is explained in the following sections.

STDMA Mode

The items in the STDMA menu will vary depending on the function the target
CDM-570/570L performs in the network. The CDM-570/570L STDMA menu
shown in figure 3-6 is from a CDM-570/570L serving as a Hub in the network.
For comparison, the STDMA Mode menu for a CDM-570/570L operating as a
Remote unit is shown in figure 3-7. Note that some of the command items differ
between these two screens, and most of the items on the Remote screen are
information-only display.