Cabletron Systems 8H02-16 manual Remove the screw from the rear standoff. Save the screw

Installing Optional Fast Ethernet Interface Modules

When installing Fast Ethernet Interface Modules in both port

TIP slots 15 and 16, remove the coverplates from both slot openings. In the following instructions, the optional module is shown being installed in port slot 16.

To remove a coverplate, refer to Figure C-4 and proceed as follows:

a.Remove the two screws fastening the coverplate to the standoffs. Save the screws.

b.Lift and remove the coverplate from the top of the front standoffs.

Coverplate

FE-	10
100TX	100

Rear

Standoff

Front

Standoffs

1742-38

Figure C-4 Coverplate Removal

3. Remove the screw from the rear standoff. Save the screw.

When installing an FE-100FX module into the 8H02-16,

!remove the rubber plug on the module before proceeding.

C AUT IO N

8H02-16 User’s Guide C-7