Configuring the Trap Table
Enable Traps (Toggle)
Enables transmission of the traps to the network management station with the associated IP address. This field toggles between [YES] and [NO].
6.9CONFIGURING THE TRAP TABLE
To configure the Trap table, proceed as follows:
1.Using the arrow keys, highlight the appropriate Trap Destination field.
2.Enter the IP Address of the workstation that is to receive traps. IP address entries must follow the DDN format.
For example: 134.141.79.121
3.Press ENTER. If an invalid entry is entered “INVALID IP ENTERED” is displayed in the Event Message Line.
4.Using the arrow keys, highlight the Trap Community Name field. Enter the community name.
5.Press ENTER.
6.Using the arrow keys, highlight the Enable Traps field. Press the SPACE bar to choose either [YES] (send alarms from the
7.Using the arrow keys, highlight the SAVE option and press ENTER. The message “SAVED OK” appears on the screen.
NOTE |
Exiting without saving causes a “NOT SAVED?” message to appear above the SAVE command. Edits will be lost if they are not saved before exiting.
8.To exit the screen, use the arrow keys to highlight RETURN and press
ENTER.
The designated workstations now receive traps from the
|
