Compaq HSZ80 manual 36Configuring Storagesets, Locate disk-name, Delete disk-name

4–36Configuring Storagesets

Use the following procedure to move a storageset while maintaining the data it contains:

1.Show the details for the storageset you want to move. Use the following syntax:

SHOW storageset-name

2.Physically label each member with its name and PTL location.

If you do not have a storageset map for your subsystem, you can enter the LOCATE command for each member to find its PTL location. Use the following syntax:

LOCATE disk-name

To cancel the locate command, use the following syntax:

LOCATE CANCEL

3.Delete the unit-number shown in the “Used by” column of the SHOW storageset- name command. Use the following syntax:

DELETE unit-number

4.Delete the storageset shown in the “Name” column of the SHOW storageset- name command. Use the following syntax:

DELETE storageset-name

5.Delete each disk drive—one at a time—that the storageset contained. Use the following syntax:

DELETE disk-name

DELETE disk-name

DELETE disk-name

6.Remove the disk drives and move them to their new PTL locations.

7.Add each disk drive to the controller’s list of valid devices. Use the following syntax:

ADD DISK disk-name PTL-location

ADD DISK disk-name PTL-location

ADD DISK disk-name PTL-location