Compaq HSZ80 manual Restart Othercontroller Restart Thiscontroller

2–13

8.If you are configuring controllers in transparent failover mode, prefer some or all SCSI target ID numbers to the controllers. Use the following command:

SET THIS_CONTROLLER PORT_1_PREFERRED_ID = (n, n)

or

SET THIS_CONTROLLER PORT_2_PREFERRED_ID = (n,n)

where n,n is a subset of the target ID numbers you declared in step 5.

See “Using Preferred ID Numbers,” page 2–35,for details about preferred SCSI target ID numbers.

9.Set the host function mode for the controller using the target ID numbers set in step 7 and in step 8. Use the following command:

NOTE: The default host function mode defaults to Host Mode A. The

HOST_FUNCTION switch changes the host function mode to a different mode.

SET THIS_CONTROLLER HOST_FUNCTION= (ID, MODE)

or

SET OTHER_CONTROLLER HOST_FUNCTION= (ID, MODE)

To change the host function mode, see “SET controller,” page 5–91for information on the HOST_FUNCTION switch.

10. Restart the controllers using the following command:

NOTE: After restarting the other controller, the EMU alarm will sound. To stop it, restart this controller.

RESTART OTHER_CONTROLLER

RESTART THIS_CONTROLLER

See “RESTART controller” in Chapter 5, “CLI Commands.”

Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide