Compaq HSZ80 manual Run, 86CLI Commands, RUN program-name, Program-name

5–86CLI Commands

RUN

Runs a diagnostic or utility program on “this controller.” Diagnostic and utility programs only run on “this controller.”

Syntax

RUN program-name

Parameter

program-name

The program-nameparameter specifies the name of the diagnostic or utility program to be run. The following programs can currently be run:

■CHVSN—This is not a user utility. This utility may be used by Compaq authorized service personnel only.

■CLCP—A utility used to load updated software code or patches. See Upgrading the Subsystem in the Maintenance and Service Guide for more information regarding this utility.

■CLONE—A utility used to automate the process of mirroring units to create a snapshot copy of host unit data. See “Cloning Data for Backup,” page 3–20,for more information regarding this utility.

■CONFIG—A utility used to locate and add devices to the controller configuration. CONFIG may be run anytime new devices are added to the subsystem. See “Adding Disk Drives,” page 4–2,for more information regarding this utility.

■DILX—A utility used to test and verify the controller’s operation with attached storage devices under a high or low I/O load. Run DILX (disk inline exerciser) only when there is no activity on the controller. The total I/O load is handled by the controller, bypassing the host.

The DILX utility has two modes, an autoconfigure mode, and a standard mode.