Compaq HSZ80 manual 126CLI Commands, SET RAID9 POLICY=BESTFIT, SET RAID9 REMOVE=DISK10000

5–126CLI Commands

REPLACE=disk-name

Instructs the controller to add a disk member to an existing RAIDset if the following conditions are met:

■The replacement policy is set to NOPOLICY.

■The disk member is not in any configuration, including a spareset.

An error is displayed and the command is rejected if the RAIDset is not in a reduced state, if a replacement policy is already specified, or if the disk specified is already being used by a configuration (including a spareset).

NOTE: Do not specify other switches when you use the REPLACE switch.

Examples

This example shows how to change the replacement policy for RAIDset RAID9 to BEST_FIT:

SET RAID9 POLICY=BEST_FIT

This example shows how to remove member DISK10000 from the RAID9 RAIDset:

SET RAID9 REMOVE=DISK10000

If there is a replacement policy, the controller moves a disk from the spareset to the RAIDset automatically.