Dell R300 owner manual Warning Messages

Table 1-7. System Messages (continued)

Message	Causes	Corrective Actions
Warning! Embedded	Embedded RAID	See "Using the System Setup
RAID firmware is	firmware does not	Program" on page 46.
not present.	respond.
Warning! Embedded	Embedded RAID	See "Using the System Setup
RAID error!	firmware responds with an	Program" on page 46.
	error.
Warning: The	Invalid memory	Ensure that the memory
installed memory	configuration.	modules are installed in a
configuration is		valid configuration. See
not optimal. For		"Memory Module
more information on		Installation Guidelines" on
valid memory		page 102. If the problem
configurations,		persists, see
please see the		"Troubleshooting System
system		Memory" on page 135.
documentation on
support.dell.com

Write fault

Write fault on selected drive

Faulty USB device, USB medium, optical drive assembly, hard drive, or hard-drive subsystem.

See "Troubleshooting a USB Device" on page 127, "Troubleshooting an Internal USB Key" on page 137, and "Troubleshooting a Hard Drive" on page 142.

NOTE: For the full name of an abbreviation or acronym used in this table, see the "Glossary" on page 167.

Warning Messages

A warning message alerts you to a possible problem and prompts you to respond before the system continues a task. For example, before you format a diskette, a message will warn you that you may lose all data on the diskette. Warning messages usually interrupt the task and require you to respond by typing y (yes) or n (no).

NOTE: Warning messages are generated by either the application or the operating system. For more information, see the documentation that accompanied the operating system or application.

About Your System

43