Removing a
1Remove the front bezel, if attached. See "Removing the Front Bezel" on page 67.
2Locate the pushbutton locking tab on the right side of the blank to release the
3Slide the
Installing a Hard-Drive Blank
Installing the
1Remove the front bezel, if attached. See "Removing the Front Bezel" on page 67.
2Locate the
3Insert the
4The pushbutton locking tab should click as the drive blank snaps into place.
5Replace the front bezel, if it was removed in step 1.
Removing a Hot-Plug Hard Drive
1Remove the front bezel, if attached. See "Removing the Front Bezel" on page 67.
2From the RAID management software, prepare the drive for removal and wait until the
If the drive has been online, the green activity/fault indicator will flash as the drive is powered down. When both drive indicators are off, the drive is ready for removal.
3Open the drive carrier release handle to release the drive. See Figure
4Slide the hard drive out until it is free of the drive bay.
74
Installing System Components