Dell R300 owner manual Installing the System Board Shroud, tab slots

Figure 3-5. Installing and Removing the System Board Shroud

1 2

3

			4
1	system board shroud	2	tabs (3)
3	SAS cable connector	4	tab slots (3)

NOTE: In the preceding figure, the 12C cable is shown connecting over the control panel cabling. This cable should be routed under the control panel cable and the internal USB key connector. The 12C cable seats in a cable guide clip that is directly beneath the control panel connector.

Installing the System Board Shroud

1Align the shroud using both ends of the numbered fan bays as a guide and locate the three tab slots on the left and right sides of the fan modules and a third tab at the upper right corner in front of the memory modules. See Figure 3-5.

2Push the system board shroud down until all edges are seated in the slots, securing the shroud to the system board.

72

Installing System Components