Dell R300 owner manual Installing the Riser Card, Pins

Figure 3-16. Installing and Removing the Riser Card

1 2 3

4

5

	6
1	riser card release latch	2	riser card connector
3	left riser card	4	center riser card
5	riser card connector	6	center riser card alignment
			pins (2)

Installing the Riser Card

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.

1Align the riser board with the alignment pins on the system board, then lower the board onto the pins.

2Press down on the riser board until the edge connector(s) on the board is (are) fully seated in the riser board connector on the system board. See Figure 3-16.

Installing System Components

99