6Disconnect the display module cable from the control panel board. See Figure
7Remove the three screws that secure the control panel board to the system chassis and remove the board. See Figure
8Remove the display module:
a Insert the end of paper clip into the hole on the right side of the display module and gently pry off the label.
b Using a T10 Torx driver, remove the two screws that secure the display module to the system chassis.
c Remove the display module from the chassis cutout.
Installing the Control Panel Assembly
1Insert the display module into the chassis cutout and secure with the two Torx screws.
2Affix the display module label to the display module.
3Install the control panel board in the system chassis and secure with the three Phillips screws. See Figure
4Connect the display module cable to the control panel board. See Figure
5Connect the internal USB key cable and, if applicable, the
6Connect the control panel cable to the control panel board. See Figure
7Close the system. See "Opening and Closing the System" on page 68.
8Reconnect the system to the power source and turn on the system and attached peripherals.
9If applicable, install the bezel.
Installing System Components
115