Dell R300 Diskette subsystem, Reset failed, Drive not ready, Error Remote, Access Controller

Table 1-7. System Messages (continued)

Message	Causes	Corrective Actions
Diskette subsystem	Faulty diskette/tape drive	See "Troubleshooting a
reset failed.	controller.	Diskette Drive" on page 138.
Drive not ready.	Diskette missing from or	See "Troubleshooting a
	improperly inserted in	Diskette Drive" on page 138.
	diskette drive.
Error: Remote	The Remote Access	Ensure that the Remote
Access Controller	Controller failed to	Access Controller is properly
initialization	initialize.	installed.
failure

Error 8602 -	The mouse cable
Auxiliary Device	connector is loose or
Failure	improperly connected, or
Verify that mouse	the mouse is defective.
and keyboard are
securely attached
to correct
connectors.

Check the connection from mouse cable to the system. If the problem persists, try another mouse, or see "Getting Help" on page 165.

Fatal Error caused a system reset:

Please check the system event log for details

A fatal system error occurred and caused the system to reboot.

Check the SEL for information that was logged during the error. See the applicable troubleshooting section in "Troubleshooting Your System" on page 123 for any faulty components specified in the SEL.

Gate A20 failure	Faulty keyboard	See "Getting Help" on
	controller; faulty system	page 165.
	board.

General failure	The operating system is
	unable to carry out the
	command.

This message is usually followed by specific information. Note the information, and take the appropriate action to resolve the problem.

36

About Your System