Using the CORFIX Program

To configure your computer for use with the RampagePlus 286 memory card, you need to use CORFIX, an Epson utility on your Reference diskette, and SMART, the RampagePlus 286 setup program. You must use CORFIX before you use SMART.

If you have a hard disk, you can copy the CORFIX program from your Reference diskette to your hard disk before you run the program. See “Copying the Reference and Utility Files” in Chapter 3 for more information. Then follow the instructions below to run the CORFIX program from your hard disk.

Follow these steps to run the CORFIX program:

1.If necessary, turn on your computer. Make sure the MS-DOS command prompt appears on your screen.

If you do not have a hard disk, insert your Reference diskette in drive A and turn on the computer. At the Operation Menu, select Exit to MS-DOS for more utilities and press Enter. If necessary, type A: and press Enter to log onto drive A.

2.At the C> or A> prompt, type CORFIX and press Enter. The following messages appear:

T h e p r o g r a m w i l l c o n f i g u r e t h e system to work with the SMART utility when installing the Rampage plus 286.

SMART can only be executed immediately after this configuration program. Continue ? (Y/N)

Installing and Removing Options

5-37