3.To run the program, press Y; to exit to MS-DOS without running CORFIX, press N. If you press Y, you see the MS-DOS prompt and this message:

Configuration completed. The SMART installation utility may now be used.

4.Use the SMART setup program now. See your RampagePlus 286 manual for instructions.

Post-installation Setup

After you install or remove a math coprocessor or memory modules, you need to run the Setup program on your Reference diskette so it can automatically update the computer’s configuration information. If you install or remove any other type of option, such as an option card or a disk drive, it is important to run Setup to check if you need to change any settings. For example, if you add a hard disk drive, you need to let the computer know the type of drive you have installed. See Chapter 2 for instructions.

If you install a hard disk drive that has never received a hardware level format (such as some non-Epson hard disk drives), you may need to format the disk. Check the manual that came with your hard disk drive, and then, if necessary, follow the instructions in Appendix C to format your new hard disk.

If you have added a hard disk drive and you want to load MS-DOS or another operating system from that drive, you need to install the operating system on it. See your MS-DOS Installation Guide or the documentation that came with your operating system for instructions.

5-38 Installing and Removing Options