Replacing the Drive on the Subassembly
This section describes how to reinstall your hard disk drive in the vertical mounting position. The following illustrations show the subassembly installed inside the computer with the front panel attached. However, you can install the drive the same way, whether the subassembly is installed already or not. Follow these steps:
1.Pick up the hard disk drive and hold it above the right side of the subassembly with the mounting plate facing the subassembly, as shown below.
Notice that there are two tabs facing downward on the bottom of the mounting plate. These tabs fit into two slots in the right side of the subassembly when you install the drive.