Moving the Cursor Block

Use 1 and ? to move the cursor block (the highlighted bar) through the options on the main Setup menu. After you highlight the option you want, press Enter to select it.

you need to enter numbers while and you want to use the numereric turn it back on.

Follow the instructions in the rest of this chapter to use the Setup program to define your computer’s configuration.

Setting the Display Adapter Type

The Setup program can usually detect the exact type of display adapter you are using with your computer. If you have connected a VGA monitor to the built-in VGA port, the Setup program automatically sets this value for the display adapter type. (With this option you select the type of display adapter you are using-not the type of monitor). If you have installed a display adapter card-or you just want to check the display adapter setting-follow these steps.

I

N o t e .

If you have installed a display adapter card that is not a VGA or an EGA card, you must set jumper J6 an the main system board to disable the built-in VGA interface so that your card can operate as the primary display adapter. See Chapter 4 for instructions on changing jumper settings.

2-6 Running the Setup Program