If you want to save the settings you entered, highlight

**EXIT AND SAVE ** and press Enter at a Setup summary screen. The Setup program stores the new settings and resets the computer using the new configuration. If you have set a password, you need to enter it at the key prompt. (See “Using a Power-on Password” in Chapter 3 for instructions.) The Operation Menu appears. Press 0 and Enter to exit the Operation Menu.

After you save the settings you entered, remove the Reference diskette from your diskette drive and turn off your system. Then follow the instructions in your MS-DOS Installation Guide to install MS-DOS. (If you are using a different operating system, follow the installation instructions in that manual.)

If the computer displays an error message while it is starting up, run the Setup program again and check the setting the error message indicates. If the computer still displays an error message after you check your Setup program settings, see Appendix E or ask your dealer for assistance.

After you have installed MS-DOS on your hard disk, you should always boot the computer from the hard disk to use MS-DOS. If you boot from your Reference diskette to run Setup or System diagnostics, remove the diskette from drive A and reset your computer when you are finished running the program. This ensures that your system performs all the commands in your CONFIG.SYS and AUTOEXEC.BAT files each time you use MS-DOS.

Note

Be sure to make a backup copy of your Reference diskette after you run the Setup program and install MS-DOS. See your MS-DOS Reference Manual for instructions on how to copy diskettes.

2-32 Running the Setup Program