Make sure you save your password setting and that you highlight ** EXIT AND SAVE ** when you leave the Setup program.

4. After you exit Setup, you see this message:

TURN OFF POWER AND CORRECT JUMPER SETTING TO ENABLE PASSWORD CHECKING

5.Remove the Reference diskette, turn off the computer, and follow the instructions under “Changing the Jumper Settings” in Chapter 5 to enable the password function by setting jumper J1 to position A.

6.If you do not have a hard disk, insert the Startup diskette in drive A. Turn on the computer. You see the key prompt (0-n-n ). If you enabled network server mode, you do not see the key prompt. Enter your new password to access the system. (See “Using the Power-on Password” in Chapter 3.)

Note

Be sure to remember your new password or write it down and

keep it in a safe place. If you forget the you enter now, you may have to repeat the procedure above the next time you turn on your computer.

D-12 Troubleshooting