If you have any trouble using your power-on password, try the following:

1.If you think you know the correct password, reset the computer and try again. See Chapter 3 for instructions.

2.If you know the current power-on password but you want to change or delete it, see Chapter 3 for instructions. (You cannot delete a power-on password and remain in network server mode.)

3.If you do not know the current power-on password and you do not want to set a new one, see “Removing a Password” below.

4.If you do not know the current power-on password and you want to set a new one, see “Setting a New Password” below.

Removing a Password

If you have forgotten your password and you do not want to set a new one, there are two ways to remove the current password:

Cl Disable the existing password

LI Disable the password function.

To do either of these procedures, you must reset a jumper on the main system board.

Note

If you are using network server mode and you remove the

Troubleshooting D-9