Stylus Photo R300/R310 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 44
2.3.5 Removing Panel Board
External View
Figure 2-12. Removing "Panel Board"
Parts/Units which should be removed before removing "Panel Board"
Paper Support Assy./Housing, Upper
Procedure for Removing
1. Remove the screws (x4) which secure "Board Assy., Panel". Then, remove
"Board Assy., Panel".
2. Remove the screw which secures "Panel Board". Then, remove "Panel Board"
from "Shield Plate, LCD".
3. Take off the two-sided tapes (x2) which secure "Cover, LCD" from the back
of "Housing, Upper". Then, remove "Cover, LCD".
Cover, LCD
Two-sided
Tapes
Switch
Line Mark
Board Assy., Panel
C.B.P 3x8 (4-6kgf•cm)
1
2
3
4
Shield Plate, LCD
C.B.S 3x8 (4-6kgf•cm)
Panel Board LCD Panel
Rib and
Adjusting Hole
C A U T I O N Do not damage "LCD Panel".
When removing "Panel Board Unit", the switch may detach and
drop. If this occurs, reinstall it referring the figure.
When looking at back side of "Housing, Upper", make sure that
the line mark of "Housing, Upper" securely comes to the position
shown in the figure.
Match the rib of "Shield Plate, LCD" and the positioning hole of
"Panel Board".
Screw "Board Assy., Panel" in the order as shown in the figure.