Stylus Photo R300/R310

Revision A

†When reassembling "ASF Assy."

„Make sure that "Extension Spring, 0.45" is hooked on "Frame, ASF" and "Roller, Retard Assy.".

„Check if "Torsion Spring, 6.45" is correctly installed on "Paper Back Lever" and "Frame, ASF".

Torsion Spring, 6.45

Figure 2-19. Removing "Torsion Spring, 6.45"

„Check if "Paper Back Lever" and "Roller, Retard Assy." move smoothly.

„Do not touch the cork of "Hopper".

†Reinstalling "ASF Assy."

„Install "Compression Spring, 2.51" on "Hopper", then check if "Hopper" moves smoothly.

„Screw in the order as shown in the figure.

„Make sure that there is no gap between "ASF Assy." and "Frame, Main".

ADJUSTMENT † When having replaced "ASF Assy.", apply G-46 grease to the

REQUIRED specified points in adequate dose. (Refer to Chapter 4 "MAINTENANCE")

†When having replaced or removed "ASF Assy.", implement the adjustment in the following order. (Refer to Chapter 3 "ADJUSTMENT")

1. First Dot Adjustment

DISASSEMBLY AND ASSEMBLY

Disassembly

50

Page 50
Image 50
Epson R310 service manual Torsion Spring